Pyrexx is a German company that launched a very high-quality and modern smoke detector with the PX1 smoke detector. For the smoke detector, the most modern detection technology was used and it is used almost in all areas. Examples at this point are corridors, living rooms, bedrooms, heating rooms and garages.Please note that smoke detectors up to 40 m² are suitable for maximum room size. The smoke chamber is turbine-shaped and the bi-sensor processor technology is used. This allows a permanent evaluation of smoke and heat in the measurement data. The Pyrexx PX1 is therefore also cuchaugauglich and can be used this also in the Kleingewerbe. The only important thing is that no welding, gas or sawing work takes place in the rooms. The Pyrexx PX1 Smoke Detector uses bi-sensor technology to enable optical classical smoke detection as well as permanent temperature analysis. This means that the temperature changes are monitored. From the processor of the smoke detector the two measured values are permanently fixed and also evaluated. In the technology, temperature and smoke are monitored and the false alarms are almost impossible. It can also be used without problems in the smoky environments such as the cigarette smoke. Both of the PX1 smoke detectors also have the periodic self-test function, which has a time window as a time window. In the case of detection optics, the sensitivity is then always adjusted as a function of the environmental influences and a condition is indicated with a signal tone. Examples here are that the sensor system is contaminated or the battery power is reduced. The smoke detector provides an easy-to-use and large test button. This can trigger a test alarm and the alarm triggered can also be switched off.  

The battery

It is a solid lithium battery. This means that the lithium battery has been soldered firmly to the smoke detector. The smoke detector receives sufficient electricity for a period of twelve years with the help of this battery. Thus, the device is of course absolutely low-maintenance. If the battery reserve has been reached, a signal tone will appear every ninety seconds. In this context, it is important that the Pyrexx PX1 smoke detector is a closed system. It is not necessary to change the battery and this does not work technically either. The device must be completely replaced when the smoke detector has reached its service life.  

The design and assembly

The smoke detector, apart from the extensive features, can also convince by the appealing design. The lamellas are nice and the PX1 can stand out from the other smoke detectors. The smoke detector is available in 33 different colors, from mattgold to pure white. Your own taste can decide the right color. The lid from the smoke alarm can be removed and it can be individually designed. There are varnishes and foil stickers. With the PX1 the dimensions are a height of 3.8 centimeters and a diameter of 10 centimeters. The dimensions are very low and there are no disturbing LED flashing signals at the smoke detector. This also makes it possible to use the bedroom in the bedroom. The smoke detector is held by a magnetic carrier, but there are two possibilities for the PX1 to be mounted on the ceiling. The magnetic carrier can be mounted with the hot glue, so that it does not have to be drilled. Otherwise, there is the MSS system just the drilling installation. The drill mounting is very easy with the model, because only one screw with 5 millimeters has to be used centrally.