Technical characteristics
| Dimensions |
59.2 x 59.2 x 3 cm |
| weight |
5 kg |
| voltage |
230 V |
| protection class |
IP 44 |
| power |
300 Watt |
| thermal protection |
not available |
| surge protection |
not available |
| wall - and ceiling mount |
available |
| special |
mineral-coated surface and rear suspension device |
Advantages
- ease of use
- easy Assembly
- good heat distribution
- modern
- flexible
disadvantages
- no connector on the cable
- not suitable for larger rooms
- No thermostat included
because no fixed heating system is installed in some smaller rooms, for example, in lounges, many consumers rely on infrared heating. These heaters have the advantage that only heat is emitted if the consumer wants to do. A very beautiful heater is the Fenix Ecosun 300 U infrared heating. This is because because the heating system consists of high-quality materials and all the details fit together perfectly. The largest and probably the most important advantage of an infrared heater is that they are environmentally conscious and energy-saving work. At the Fenix Ecosun 300 U infrared heating is most definitely the case.
Scope of delivery – well put together
consumers, allowing to send Ecosun infrared heating will not be disappointed. This is firstly because heating visually is a true eye-catcher. There is also still the bracket to the ceiling or the wall and cable in the package. In this model, make sure there is no connector for the cable with. So the Assembly goes faster by hand, mounting instructions enclosed in addition. This ensures that immediately after unpacking the installation can begin. So in the time get this, where is the infrared heater on the way. To install
Assembly - a no-brainer
to infrared heating, no major precautions are necessary. That is, the consumer draws on the mass of the wall or ceiling, be sure that these result in a straight line. Then the bracket firmly on both sides and you're done. The only requirement is that a suitable power source in close to the hotel.
Where the infrared heater install?
Every consumer decide where the heater in the room to find their place. Usually that depends on them, where the thermal power can best develop. The product dimensions of 59.2 x 59.2 x 3 centimeters are there not an obstacle. Also the total weight of five kilograms plays a minor role. The highlight is the neutral white colour and the timeless modern design. Due to these features, the heating of easily any body adapts. Should meet the white color not the taste of the consumer, no problem, the heater can be simply painted over.
Commissioning - an easy task
for infrared heating by Ecosun is at all to the heat source, a plug with the mains cable must be added together first. This step is completed, simply bring the power source in combination. For this purpose a standard 220-240 volt power supply is perfectly sufficient. The surface
facilities - very modern
the Fenix Ecosun 300 U infrared heater is a plate of Thermocrystal. This material is said that the heat is delivered perfectly and consistently. The coating also ensures. The maximum heating power is 300 Watts. Therefore, the consumer in advance should look whether the room for the performance is not too large. For the 300 Watts, the room should be no larger than 10 square meters. The cable has a length of two metres. The radiation of heat is 2.5 greater than at other infrared heaters this heater. The highlight of the heating is the protection class. This is IP 44. Therefore, the heater also for wet rooms is suitable. This means that if the heater comes into contact with water spray, a short circuit is not immediately raised.
Conclusion
Consumption r, seeking an additional heating source for a smaller space, 300 U are well served with the Fenix Ecosun infrared heating. Daily application and that any painting over the heating take no negative influence on the performance. Therefore, the value for money is excellent. In addition, the heater has no excessive wear.
