Technical characteristics
| Action |
electrochemically |
| Battery type |
E-Block |
| function test |
automatic self-test manual |
| battery number |
1 |
| operating voltage |
9-volt |
| sound pressure level |
85 dB |
| coverage |
unspecified |
| function test |
available |
| Mute button |
not available |
| special |
battery control display |
Advantages
- good quality
- different alert thresholds
- very loud alarm
disadvantages
- found no serious disadvantages
because we have a gas water heater, we wanted to have detectors for security CO. At the time of purchase we chose detector the ELRO RM335 CO. Our experience with this CO detector you can see in this review.
Therefore, it became the ELRO RM335 CO detectors
when buying a CO detector was us mainly one very important, the quality should be. Also, detectors should be not too large CO. Best meets this has detectors in our opinion of the ELRO RM335 CO. At this CO detectors have convinced us is several points. For example the different alert thresholds where he raises is one of these points. Also, the alarm should be very loud. Also convinced us that he carries out an automatic self-test. Ultimately, these were the reasons that led to the purchase of the ELRO RM335 CO detector.
Technical data to the CO detector by ELRO
from plastic is made of the ELRO RM335 CO detectors. For the operation, Sparmelder powered by ELRO requires an alkaline 9 volt battery CO. The CO detector is set with different parameters, so detectors throws, CO at a concentration of 50 ppm within by up to 90 minutes at 100 ppm within 40 minutes and 300 ppm in 3 minutes. The registration is done through a Nemoto sensor. The alarm at the CO detector is very loud 85 DB. It is equipped with a test and a reset button. Also, detector CO has a tone for a weak battery. Operation of the CO detector will be shown via a small led in the colors green and red. It can be used at temperatures from 4 to 38 degrees. The dimensions of the CO Sparmelder powered by ELRO are 17.5 x 4.5 x 11.5 cm. He is on a weight of 141 grams. Colour, it is kept fully in a white shade. The ELRO manufacturer gives a guarantee of three years.
Included in the ELRO RM335 CO detectors
ELRO RM335 CO detector is supplied with many accessories. This accessory is not only a manual, but also a 9 volt battery for the operation and appropriate mounting material. The mounting material here consists of two screws and wall plugs. You can not only notes for the operation, but also for the mounting of the operating instructions. It is very clear.
For Sparmelder powered by ELRO is CO
the CO detector by ELRO can be versatile. So this not only with a gas water heater or a gas stove, but also wood and tiled stoves and garages is suitable. When using it must consider only the temperature range in which one can use the CO detectors.
Handling of the CO detector
the handling of the ELRO RM335 CO detector is very easy. Through the supplied mounting material and the manual, is the CO detector quickly and easily mounted. You can remove this at any time again with a handle, for example, for a battery change. The operation itself, to do much. So this itself performs a self test and the battery voltage is monitored.
Conclusion
Very well-finished plastic is the ELRO RM335 CO detectors. It is equipped with a sensor and three different thresholds. The respective operating status is displayed via an LED lamp. It is supplied with a battery and installation material. Detector we have observed in the use of the CO no deficiencies. Rather, it convinces by its user-friendly handling. So much do you except the Assembly and change the batteries if necessary. We are un the ELRO RM335 co detector very pleased d can recommend these.
