Since the old well pump was broken, we needed a new one for the garden irrigation. Because of the choice, our decision was not so easy. Among other things due to their processing, however, we have opted for the AL KO TBP 4800 8 well pump.  

Therefore, the AL KO TBP 4800 8 well pump

The new well pump should promote as much water in the hour as we have a small garden. In addition, it was important to us that the well pump is made of stainless steel. With these two requirements we have looked for a suitable well pump. Our choice has finally fallen on the AL KO TBP 4800 8 well pump. With this well pump several factors have convinced us. In addition to processing, this was also the extensive safety equipment. In addition, it has convinced us altogether because of its processing. For these reasons, we have also opted for the AL KO TBP 4800 8 well pump.  

Technical data for the AL KO well pump

The AL KO TBP 4800 8 well pump is made of stainless steel. It is equipped with an eight-stage pump gearbox. The well pump is powered by a 230 volt connection and is equipped with a connection cable. One can pump up to 4800 liters of water with the well pump. The discharge height is limited to a maximum of 60 m. For protection, the well pump is equipped with a non-return valve as well as a thermal and blocking protection. This can not block the well pump or overheat the electric motor. Cooling from the engine at the well pump is done by water cooling. The well pump from AL KO comes in dimensions of 9.8 x 9.8 x 45 cm, weighing 10 kg. It is held in a silver shade for stainless steel. The AL KO TBP 4800 8 well pump is supplied together with a weather-resistant drain cable. This is attached directly to the well pump.  

Installation of the AL KO TBP 4800 8 Well pump

The installation of the AL KO TBP 4800 8 well pump is very simple. Where I have imagined this quite difficult. So you have to drain the well pump simply with the existing drain cable into the well. For this to be possible, the well must have a minimum width of 10 cm. There are no more requirements for the well at the installation. Otherwise, you only have to connect the well pump with a power source via the existing connection cable. Here we at least found with us, the cable could be a bit longer.  

Handling the AL KO TBP 4800 8 Well pump

How easy the installation is, I already mentioned. However, our expectations were also fully fulfilled during handling. The amount of water that the well pump pumps is very good. In addition, the well pump works relatively quietly. What convinced us at the time of purchase, but now also in the use of the well pump are the safety devices. If the fountain pump sucks dirt, it will immediately turn off. The existing non-return valve at the well pump also prevents a return of water into the well. Not to be neglected is, of course, also the maintenance, but this is due to the manufacture of stainless steel is not a lot of effort. One comes with the wellpump well to all places and through the surface of stainless steel, can not stick to it much. Due to the existing drain cable, the well pump is easily accessible at any time.