A deep-water pump is an indispensable utensil in every garden, for example a cistern or a well. The Zehnder well pump is really unique and has an asynchronous motor. This is equipped with a thermocontact. The pump is easy to insert and the user can connect it perfectly with a water hose.In normal cases, the pump will always be able to work and therefore it is very usable for most. It is a pump, which is a reliable tool in the garden, which is equipped with a jacket flow cooling system. This makes continuous operation no problem at all.  

Ordering and delivery of the Zehnder TM31

Any buyer or prospective buyer of the pump can make an order immediately. Therefore, the pump is shipped accordingly and it works very well. The pump is also immediately ready for use after delivery. All that is needed is a suitable hose to transport the water. But if the hose has been connected then can start pumping.  

How must the pump lie?

The pump can either be used completely in a lying position, or half-dipped. An additional cooling jacket is not required. Only the best materials are used for the pump. The pump mainly consists of stainless steel. This applies at least to the housing and the motor shaft. The bearing plates are made of brass. In the Zehnder deep-well pump, running wheels and guide wheels are made of a very wear-resistant plastic. The mechanical seal is made of a silicon carbide, which is very good. The pump is equipped with a very good and also usable pump hydraulics, which will be extremely useful for the buyer. As a result, the performance here will not only be present, but is also very strong. This is achieved by the pump with a low energy consumption.  

The applications of the Zehnder deep-well pump

The pump is perfect for transporting water from a cistern or a well. Moreover, it is very well suited to have the entire garden water used for watering the plants. The pump can also supply the entire house with water. It can therefore be used as a service water pump. Farmers can also benefit from the Zehnder well pump. The pump is perfect in agriculture and can be used for animals or the irrigation of green areas.  

The technical data!

The whole pump is extremely thin and has a diameter of only 78mm. The pressure port has an internal thread and measures an inch. The power consumption of the device is P1 860 Watt and P2 460 Watt. The voltage is completely normal and the current should be 3.8 Ampere. The volume flow, which can get maximum from the pump is indicated with 3.1 cubic meters of water in the hour. This is very much and will also be very suitable for pumping upwards. The maximum discharge height of the pump must not exceed 57 meters. The volumetric flow can, however, still be adjusted and can be at about 15 cubic meters per hour at approximately 41 meters of headroom. The weight of the pump is 12 kilograms.  

The scope of supply

The pump comes naturally with a 20 meter long connection cable. This is also suitable for underwater use. The pump also has a Schuko plug. This will give additional security. The capacitor is already included. There is also a power switch that has a motor protection. If something should be with the pump, then it can turn off.  

What if something is?

Of course, it can happen again and again that this pump has a fault. This should be rectified immediately. If something does not work with the pump, then it is important to inform the seller immediately. Because only in this way can the problem be solved quickly. If possible, the pump should be replaced if the defect can not be remedied.