The Ebara Idrogo M 80 15 well pump is a vertically operating pump with very high quality. In a practical test, this pump was once tested exactly for its good properties. This pump shows the high quality of stainless steel stainless steel. Well pumps like these from the French manufacturer Ebara also technically have the required quality that a user needs. The use of this pump is possible for many purposes and this was proved by the incoming test. 

Versatile and very reliable

Ebara applies its products with many good properties and this pump is also suitable to provide a well as a well pump in a bored shaft or as a useful supplement in a home water system of a cistern to provide its service reliably and continuously. If you are looking for such a special pump, you would like to know how well this pump works without problems and what can be expected? With a diameter of the slim pump housing of 5 cm, this pump is ideally suited to be used in a shaft bore for a deep well. This pump has the rare property of being used up to a depth of 20 m, which in turn means a lifting depth of around 20 meters, a well can then be deep. Also the considerable operating pressure is very astonishing, because this pump can generate very high pressure which has a positive effect in the further connection network. 7200 liters per hour is the maximum flow rate that this well pump is capable of promoting and the test confirmed these values.  

Special applications with excellent quality

This pump has been very convincing as a result of the tests, since this pump is a special feature of the construction of its design. Particularly noteworthy is the lifting capacity in height. As already described, a reduction to the 20 meter mark was made in the test. The manufacturer describes the lifting capacity with a height of 57 meters. This means for the user that he has not only the 20 meters lifting capacity of the lowering available, but also 37 meters additionally as lifting height gets. These values were also confirmed in the test and here, too, one can only speak of admirable recognition for the technical performance. This pump has a very good pumping inside, although it is a very small pump. The Ebara Idrogo M 80 15 fountain pump can be easily integrated into a waterworks as a pressure boosting pump. The test sequence has also been made in this respect and the connection for the user is quite easily possible via the standardized connections. In the test, the outstanding quality of this product convinced in every detail. Of course, each product also has weaknesses and here it was found in the test that the manufacturer could have used the retaining eyelets to lower the pump of stronger eyelets. According to the test team, this weak point poses the risk that the pump can not be lifted once after some time.  

Technical specifications

The power of this pump from the test is indicated with 1100 watts. This appears to be very good for the entire construction of the construction. The temperatures that are passed through in this pump body can have temperatures of 40 degrees Celsius and this pump has a float as safety equipment and as a service switch. The supply cable is just sufficient with a length of 20 m and is also a disadvantage in the opinion of the test team because this dimensioning should be at least 5 meters longer to facilitate a versatility of the connection possibilities in the technical design. The entire pump is equipped with a double mechanical casing, which creates an oil chamber for the lubrication of the pump. This is critical in the overall set-up and gives the test team a comment on the criticism. This technical solution should consider the manufacturer once, but this comment is not to be seen as a good overall judgment on this product. The displacement in the well shaft is 1 "to 1/4 and this is a remarkably good value compared to other products. The customer gets a completely mature product, which is appreciably well designed.